[Nov 23, 2023] Get Latest and 100% Accurate 350-501 Exam Questions
Maximum Grades By Making ready With 350-501 Dumps
Cisco 350-501 certification exam is designed for professionals who want to demonstrate their expertise in implementing and operating Cisco service provider network core technologies. 350-501 exam covers a wide range of topics, including network automation, VPN services, QoS, MPLS, and network architecture. Candidates who pass 350-501 exam will be awarded the Cisco Certified Specialist - Service Provider Core certification.
NEW QUESTION # 181
In an MPLS VPN environment, the QoS making over the MPLS backbone must be different from the one that is received from the customer. The forwarding on the egress PE is based on the marking that is set by the ingress PE. Which null label and QoS mode can achieve this?
- A. MPLS implicit null with uniform mode
- B. MPLS implicit null with pipe mode
- C. MPLS explicit null with uniform mode
- D. MPLS explicit null with pipe mode
- E. MPLS explicit null with short pipe mode
- F. MPLS implicit null with short pipe mode
Answer: D
NEW QUESTION # 182
A network team has failed to implement IS-IS multitopology. What is the reason for it?
- A. The routing process did not support extended metrics.
- B. The routing process supported Level 1 only.
- C. The router did not have Cisco Discovery Protocol and Cisco Express Forwarding disabled.
- D. The router did not support VRFs.
Answer: A
NEW QUESTION # 183
Refer to the exhibit. Which statement describes this configuration?
- A. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration
- B. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
- C. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
- D. Router 1 can be remotely managed by the CLI using Telnet
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/169/b_169_programmability_cg/configuring_yang_datamodel.html
NEW QUESTION # 184
Refer to the exhibit:
An engineer is preparing to implement link aggregation configuration.
Which statement al about this configuration is true?
- A. The switch port actively sends packets to negotiate an EtherChannel using PAgP
- B. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer
- C. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer
- D. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.
Answer: A
NEW QUESTION # 185 
Refer to the exhibit. This configuration is being applied on an IOS XR route.
Which statement about this configuration is true?
- A. It is used to create a subscription to specify the streaming interval.
- B. It is used to identify MIB entries and has a list of YANG models.
- C. It is used to identify traps for SNMP polling.
- D. It is used to create a sensor-group and has a list of YANG models for streaming.
Answer: D
Explanation:
Section: Automation and Assurance
Explanation/Reference:
Reference; https://www.cisco.com/c/en/us/td/docs/routers/ncs6000/software/telemetry/b-telemetry-cg-ncs6000-
62x/b-telemetry-cg-ncs6000-62x_chapter_010.pdf
NEW QUESTION # 186
An engineer is implementing MPLS to monitor within the MPLS domain.
Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when the LSP is down?
- A. Disable IP redirects on all ingress interfaces.
- B. Configure a private IP address as the destination address of the headend router of Cisco MPLS TE.
- C. Implement the destination address for the LSP echo request packet in the 127.x.y.z/8 network.
- D. Disable IP redirects only on outbound interfaces.
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-
5/mpls/configuration/guide/b-mpls-cg-asr9000-75x/implementing-mpls-oam-74x.html
NEW QUESTION # 187
Refer to the exhibit.
An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?
- A. It is used for encoding with the default protocol buffers
- B. It is the encoding requested by the gRPC client.
- C. It is the encoding requested by the gRPC server.
- D. IT is the encoding that is used for dial-in and dial-out.
Answer: C
NEW QUESTION # 188
Refer to the exhibit.
An engineer is implementing BGP selective prefix suppression. The router must advertise only 10.16.4.0/24,10.16.5.0/24. and summarized route 10.16.0.0/21. and suppress 10.16.6.0/24. Which configuration must the engineer apply to the router?
A)
B)
C)
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: C
NEW QUESTION # 189
Refer to the exhibit. Which statement about this configuration is true?
- A. It is the configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
- B. It requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
- C. It requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
- D. It requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
Answer: A
NEW QUESTION # 190
Refer to the exhibit.
Guidelines
-
This is a lab item in which tasks will be performed on virtual devices.
* Refer to the Tasks tab to view the tasks for this lab item.
* Refer to the Topology tab to access the device console(s) and perform the tasks.
* Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
* All necessary preconfigurations have been applied.
* Do not change the enable password or hostname for any device.
* Save your configurations to NVRAM before moving to the next item.
* Click Next at the bottom of the screen to submit this lab and move to the next question.
* When Next is clicked, the lab closes and cannot be reopened.
Topology
Tasks
-
R1 and R2 are having issues forming an eBGP neighbor relationship. Troubleshoot and resolve the issue to achieve these goals:
1. Configure R1 and R2 to form a BGP neighborship using their Loopback interfaces.
2. Form the neighbor relationship using a BGP multihop mechanism. Use minimal values to solve the issue.
Answer:
Explanation:
Here is the solution:
NEW QUESTION # 191
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. All traffic to 192.168.1.0/24 is dropped
- B. Router 1 and Router 2 advertise the route to 192.0.2.0/24 to all BGFD peers.
- C. Router 1 drops all traffic with a local-preference set to 150
- D. All traffic is dropped
Answer: A
NEW QUESTION # 192
Refer to the exhibit.
A network engineer notices that router R2 is failing to install network 172.16.33.1/32 in the routing table. Which configuration must the engineer apply to R2 to fix the problem?
- A. R2(config)# access-list 1 permit 172,16,33.0 255.255,0,0
- B. R2(config)# access-list 1 permit 172,16,33.0 255,255,255,0
- C. R2(config)# access-Iist 1 permit 172.16.33.0 255.0.0.0
- D. R2(config)# access-list 1 permit 172.16.33.0 0.0.0.255
Answer: D
NEW QUESTION # 193
After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services.
For which reason do you make this decision?
- A. It requires only one edge router
- B. It enables you to choose whether to separate or centralize each individual service.
- C. It enables EGP and IGP to operate independently
- D. It is easier to manage a system in which services are mixed
Answer: C
NEW QUESTION # 194
Refer to the exhibit:
Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?
- A. The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family
- B. The neighbor relationship is down because R1 believes R2 is in AS 65012.
- C. The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement
- D. The neighbor relationship is up
Answer: A
NEW QUESTION # 195
Drag and drop the technologies from the left onto the correct definitions on the right.
Answer:
Explanation:
NEW QUESTION # 196
Refer to the exhibit. Tier 2 ISP A on AS 653 is connected to two Tier 1 ISPs on AS 321 and AS
51 respectively. The network architect at ISP A is planning traffic flow inside the network to provide predictable network services. Cisco Express Forwarding is disabled on the edge router.
How should the architect implement BGP to direct all traffic via the Tier 1 ISP with next-hop
7.4.5.2?
- A. Implement the BGP routing protocol and the maximum-paths 2 configuration.
- B. Implement the BGP routing protocol and run the bgp deterministic-med command.
- C. Implement MP-BGP with a 4-byte AS number with the bgp best path compare-routerid command.
- D. Implement BGP route-reflector functionality with the bgp always-compare-med configuration.
Answer: B
NEW QUESTION # 197
What is the function of Cisco NFV infrastructure platform?
- A. It offers consistent performance.
- B. It offers decentralized logging.
- C. It does not offer high availability.
- D. It does not have a security audit feature.
Answer: A
NEW QUESTION # 198 
Refer to the exhibit. An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?
- A. PE-A(config-if)#ip pim sparse-dense-mode
- B. PE-A(config-if)#no ip pim bsr-border
- C. PE-A(config-if)#ip pim sparse-mode
- D. PE-A(config-if)#ip igmp version 3
Answer: A
Explanation:
Section: Services
NEW QUESTION # 199
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
- A. flowspec
address-family ipv4
local-install interface-all - B. flowspec
address-family ipv4
install interface-all - C. flowspec
address-family ipv4
local-install all-interface - D. flowspec
address-family ipv4
install interface-all local
Answer: A
Explanation:
Section: Architecture
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_bgp/configuration/xe-16-6/irg-xe-16-6- book/C3PL-BGP-Flowspec-Client.html
NEW QUESTION # 200
Drag and drop the LDP features from the left onto their usages on the right.
Answer:
Explanation:
NEW QUESTION # 201
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right
Answer:
Explanation:
Explanation
Path Computation Element (Calculates paths through the network, keeps TE topology database information, sends path status updates) Path computation Client (sends path calculation request, sends path creation request) Path Computation Element (PCE) Represents a software module (which can be a component or application) that enables the router to compute paths applying a set of constraints between any pair of nodes within the router's TE topology database. PCEs are discovered through IGP.
Path Computation Client (PCC)
Represents a software module running on a router that is capable of sending and receiving path computation requests and responses to and from PCEs. The PCC is typically an LSR (Label Switching Router).
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r5-3/mpls/configuration/guide/b-mpls-cg53x-crs
NEW QUESTION # 202
Refer to the exhibit. An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. All traffic to 192.168.1.0/24 is dropped
- B. Router 1 and Router 2 advertise the route to 192.0.2.0/24 to all BGFD peers.
- C. Router 1 drops all traffic with a local-preference set to 150
- D. All traffic is dropped
Answer: A
Explanation:
All traffic to 192.168.1.0/24 is dropped by changing the n-h to 192.0.2.1 (Null0 interface).
NEW QUESTION # 203
......
Give push to your success with 350-501 exam questions: https://exam-hub.prepawayexam.com/Cisco/braindumps.350-501.ete.file.html